Sinji Front Light RF-800 CREE LED 800 Lumen Li-ion Battery

Helmet application of the RF-800

Charging Battery connected with Special adapter

Clear Green switch of the Perfect-Battery

Clear Red switch of the Low-Battery's state

Compare RF-800's outer battery to Namecard

Description of the RF-800's operation mode

• 1. 800 Lumen (Over 4hour)
• 2. 580 Lumen (Over 8hour)
• 3. 380 Lumen (Over 12hour)
• 4. 380 Flash (Over 24hour)
• * Press power button for 3 seconds to turn off.
• * Turning on, it remembers former mode and is activated from the mode.

How to operate

1. Connect RF-800 and battery as picture 1.
2. Battery is being connected, press the power button on the back side to turn on.
Red light on the button means low battery.
Battery remains about 1/4 (Approx 1 hour), please recharge the battery.

* At night, the button changes into nightglow to help you find it well.

How to Charge

After connect Adapter and battery, plug the cord into the outlet. When it is being charged, red lamp turns on and green lamp after full charged(Approx 6 hours to full charge)

How to Install

1. How to install on the Helmet

1. Place RF-800 on suitable position on the helmet to give out light efficiently. And then use
velcro tie to fix it firmly.
2. Loosen the screw on upper part of helmet bracket to adjust bracket angle.
3. Put RF-800 in the bracket with pressing locking button(Red round above).
4. After installation completed, check if it is fixed well or not.

2. How to install on the handlebar

1. After installing bracket on handlebar, tighten up bolt.
2. Loosen the screw on upper part of fixed bracket to adjust angle(Left/Right)
3. Push RF-800 towards direction of the arrow as above to install with pressing locking button (Red round above)
4. After installation completed, check if it is fixed well or not.

3. How to install Battery

1. Place battery on suitable position on frame and use velcro to tighten it up.
2. Connect RF-800 installed on handlebar and battery.

* Use included silicon tie to tidy up the line.